How does cad trim part of a circle

This article mainly introduces cad how to trim part of the circle, the article is very detailed, has a certain reference value, interested friends must read!

CAD trimming part of the circle method: first hit the BR letter on the keyboard, and then hit enter, call up the interrupt command; then select a starting point on the circle; then find another point; finally OK.

cad trimming part of a circle method:

1. As shown in the figure, there is a circle. We want to delete the upper half of the circle and leave only the lower arc part.

2. Directly type BR on the keyboard, and then type Enter to call up the interrupt command.

3. Then select a point on the circle, that is, the starting point of the arc.

4. Then find another point, that is, the interruption point.

After selecting 2 points, you can see that the upper half of the arc has been deleted, leaving only the arc we want to stay.

The above is "cad how to trim part of a circle" all the content of this article, thank you for reading! Hope to share the content to help everyone, more relevant knowledge, welcome to pay attention to the industry information channel!