How to launch the Banana Pi BPI-F2P Industrial Control Development Board from SD Card and eMMC
This article shows you how the Banana Pi BPI-F2P industrial control development board is launched from SD card and eMMC, the content is concise and easy to understand, it can definitely brighten your eyes. I hope you can get something through the detailed introduction of this article.
Install Win32DiskImager install Win32DiskImager
Open win32diskimager-1.0.0-install, choose "I accept the agreement"
First, open the software win32diskimager-1.0.0-install, select I accept the agreement, select Next >, then check Create a desktop shortcut, select Next >, then select Install to start the installation, and finally select Finish to complete the installation, as shown in the following figure:
First select "next", enter the installation directory selection (the default installation directory), then select "next", select "install" again to wait for the installation to finish, and finally select "finish" to automatically exit the installation window, SDFormatterv4 installation is complete.
SDFormat formatted SD card
First select Drive (based on the actual PC), then select "option Settings" to adjust the logical size, and "ON" is shown in the following figure.
The HDMI interface shows:
two。 Copy the required burning image compressed files to the root directory of the U disk and insert the USB seat of the B2P development board.
2021-01-29-ubuntu-mate-20.04.1-desktop-armhf-ext4-v5.4.35-bpi-f2p.img.zip
3. Mount USB flash disk to / mnt mount USB disk to / mnt
Input instruction input instruction: mount-t vfat / dev/sda1 / mnt
Input instructionto USB flash disk enter instructions to enter USB disk: cd / mnt
4. Burning the image to EMMC burn image to EMMC
Enter the following 1 instruction for Input the below instructions and like the follow picture as shown below:
Unzip-p 2021-01-29-ubuntu-mate-20.04.1-desktop-armhf-ext4-v5.4.35-bpi-f2p.img.zip | dd of=/dev/mmcblk0
Echo 0 > / sys/block/mmcblk0boot0/force_ro
Cd / root/
Dd if=xboot.img of=/dev/mmcblk0boot0
Mmc bootpart enable 1 1 / dev/mmcblk0
Mmc extcsd read / dev/mmcblk0 | grep PARTITION_CONFIG
Sync
Sync
5. Finish the burning, remove SD card and USB flash disk, Push the Red Switch PIN to off, re-power on and boot from EMMC
When the burning is complete, take out the SD card and U disk, set the red dial switch to off, and power on EMMC to start again.
The above is how the Banana Pi BPI-F2P industrial control development board starts from SD card and eMMC. Have you learned the knowledge or skills? If you want to learn more skills or enrich your knowledge reserve, you are welcome to follow the industry information channel.
