Zabbix3.2 snmp monitors switch traffic

At the beginning, I read a lot of online tutorials, but none of them were summarized, and they were all fragmented. Today, when I am free, I will simply summarize it and give help to people in need.

1. Switch configuration

I will directly above the picture, I am on the H3C configuration, cisco, huiwei, juniper and so on to see the relevant documents

Note: there is a mistake in this screenshot. I actually configured ibrzabbix, and I wrote ibr@123 casually.

2. Configuration of zabbix server

Since zabbix does not have the snmp management server installed by default, you need to install

# yum-y install net-snmp net-snmp-*

Modify a file

# vim / etc/snmp/snmpd.conf

View systemview included. # add this line

Proc mountd # remove the previous comments

Proc ntalkd 4 # remove the previous comments

Proc sendmail 10 1 # remove the previous comments

Disk / 10000 # remove the previous comments

Load 12 14 14 # remove the previous comments

Start the service

Test whether the snmp package is accepted successfully

3. Zabbix monitors host configuration

4. Check the monitoring results

I use graphtree, and the data will be available in about half an hour.