Marking method of Surface Roughness in CAD

This article is to share with you about the marking methods of surface roughness in CAD. The editor thinks it is very practical, so share it with you as a reference and follow the editor to have a look.

The marking method of surface roughness in CAD: first set polar tracking, set the angle of 30 degrees according to the diagram; then draw the first edge, pay attention to tracking the angle; finally, draw the other side according to the example of tracking.

The marking method of surface roughness in CAD:

1. First of all, we need to set up polar tracking in order to draw standard graphical symbols-- click on the polar-- settings.

2. Set a 30-degree angle according to the figure-- OK.

3, draw the first edge, pay attention to tracking the angle, the length is unlimited.

4. Follow the example shown in the diagram to draw the other side.

5. Draw the last side.

6. Add text

7, the effect as shown in the diagram, you can use the sc command to zoom in to the desired size, different roughness can change the value.

Thank you for reading! This is the end of this article on "marking methods of surface roughness in CAD". I hope the above content can be of some help to you, so that you can learn more knowledge. if you think the article is good, you can share it for more people to see!