The usage of Interlnk, Intersvr and Qbasic commands under linux

This article introduces the knowledge about "the usage of Interlnk, Intersvr, Qbasic commands under linux". In the actual case operation process, many people will encounter such difficulties. Next, let Xiaobian lead you to learn how to deal with these situations! I hope you can read carefully and learn something!

interlnk Start Simple Web Client

[Applicable occasions] If there are two computers that can be connected to a simple network through it and intersvr, this is a very good article.

command used, but rarely used

[Usage] DOS adds network support,

It allows two computers to be connected by parallel or serial lines to form a simple network

To use interlnk, you must add the following sentence to config.sys:

device=c:\dos\interlnk

Both ends of the parallel line should be 25-pin male connectors, and the connections between the pins are as follows: Corresponding

p2------------------------p15

p3------------------------p13

p4------------------------p12

p5------------------------

p6------------------------

p15-----------------------p2

p13-----------------------p3

p12-----------------------p4

p10-----------------------p5

p11-----------------------p6

p25---------------------p25 Ground

[Example] C:\DOS\>interlnk Port-LPT1

this Computer Other Computer

(Client) (Server)

----------------------------------------

E: equals A:

F: equals C:

In the client, disk E is disk A of the server, and disk F is disk C of the server.

intersvr Start Simple Web Server

[Applicable occasions] Use it, the computer becomes a server (only with DOS provided simple network)

intersvr start server

intersvr /lpt:1 Start the server and use port lpt1 as the data transmission port.

intersvr /com:1 Start the server and use com1 port as the data transmission port.

Parameters also include x baud: b v rcopy (see interlnk)

C:\DOS>intersvr

qbasic Start the Basic integration environment

[Recommendation] Probably for most people it will never be used.

If you can use qbasic language, you can use it to write your own program. Edit.com must

It's only usable if you have it.

qbasic starting basic language environment

qbasic/editor Edit languages in full screen mode

B g h mbf nohi run

C:\DOS>qbasic

"Linux Interlnk, Intersvr, Qbasic command usage" content introduced here, thank you for reading. If you want to know more about industry-related knowledge, you can pay attention to the website. Xiaobian will output more high-quality practical articles for everyone!