The method of combining multiple segments into one by cad

This article mainly introduces the method of combining multiple line segments into one by cad, which has a certain reference value and can be used for reference by friends who need it. I hope you will learn a lot after reading this article. Next, let the editor take you to learn about it.

Cad will be multiple segments into a method: first open cad, and enter "m" in the command bar to select multiple lines; then in the next command bar, enter "y" to determine the conversion of straight lines into polylines; finally, enter "j" to select merge lines.

Open cad and you can see that there are five connected lines, but they are separate, not a line segment. Then type the "pe" command.

Because it is multiple lines, enter "m" in the command bar, and then select five lines. If selected, the lines are dotted.

Then type "y" on the next command bar to make sure to convert the line to a Polyline

If you want to merge five polylines into one, you can continue, enter "j" to select merge lines, if you do not want to merge into one, you can cancel to exit the pe command after converting to polylines

If you select the segment again, you can see that it is not the previous separate state, but a complete segment.

In addition, you can also set the width of the line segment by selecting "w" under the pe command

Thank you for reading this article carefully. I hope it will be helpful for everyone to share cad's method of synthesizing multiple line segments into one. At the same time, I also hope that you will support more, pay attention to the industry information channel, and find out if you encounter problems. Detailed solutions are waiting for you to learn!