How to stretch the block as a whole by cad

Editor to share with you cad how to stretch the block as a whole, I believe most people do not know much about it, so share this article for your reference, I hope you can learn a lot after reading this article, let's go to know it!

Cad stretches the block as a whole: first select the drawing and click [Block-create]; then edit the information of the block, enter the noun of the block and click OK; then double-click the block graph to edit the block definition interface; finally, select the drawing that needs to be reduced, and enter the stretch command [S].

Cad's method of stretching the block as a whole:

1. Draw a commonly used model first, as shown in the figure.

2. Select the graphic and click * * Block * *-* create * *.

3. Edit the information of the block, click OK to enter the noun of the block, and it becomes a block.

4. Adjust the size of the block, reduce a certain size, double-click the block graph, and edit the block definition interface.

5. In the Block Editor, select the drawing you want to zoom out and enter the stretch command [S].

6. Click "close Block Editor", click Save to exit on the pop-up page, and the block is stretched.

The above is all the content of the article "how to stretch the block as a whole by cad". Thank you for reading! I believe we all have a certain understanding, hope to share the content to help you, if you want to learn more knowledge, welcome to follow the industry information channel!