TD8.0 uses mail direct to configure the mail service
1. Download a maildirect on the TD server and install it
2. Configure maildirect as shown in the figure
DNS chooses automatic detection
Only accept local users' check boxes and remove them.
The most important thing to configure mail direct is to configure SMTP relay. Here we take QQ Mail as an example, and the mail direct configuration has been completed.
3. Go to QQ Mail to change the settings
All services can be enabled.
4. Configure TD
Modify mail protocol to select SMTP SERVER and fill in the IP of the server where TD is installed
5. Fill in the mailbox for each user in TD, and the mailbox for the sender and recipient of each project must be filled in, otherwise it will lead to the failure of sending mail.
6 、
At this point, the TD mail service is configured. The most important thing here is to set up the SMTP relay of mail direct.
TD triggers the event to send email automatically. You can go to Baidu.
If the above error occurs, it means that your sender's email is not filled in.