Construction method of SECURITY-windows 2008 V pn

This article introduces SECURITY-windows 2008 V pn building method, the content is very detailed, interested friends can refer to reference, hope to be helpful to everyone.

Compare Centos 7.5 network management technology with WIN v pn technology

Using the L2TP connection, here is how to start building:

1, PPTP v pn configuration

Newly installed OS, enter the system, first add roles

Check Add Network Policy and Access Services

Check the required role service as shown in the figure

After installation, click Start-Administration Tools-Routing and Remote Access Tools

Right-click on the server as shown in the figure and select Configure and Start Routing and Remote Access Services.

Because it is a single network card machine, so choose custom configuration

Select ××× Access and NAT.

After the wizard is installed, configure the pool of addresses used to add clients with ××× connections.

Here you can also configure dhcp dynamic pool, omitted here, tested is also possible.

Then turn on NAT access according to the figure below, otherwise ××× cannot access the Internet.

Right click to add interface

At this point, the configuration of RRAS is complete, and then proceed to NPS configuration.

Client Settings

Enter the IP address of the server.

At this point, win08 pptp ××× configuration has been successfully built, at this time the client can connect to the win2008 server through ***, and can connect to the internet through ×× server.

2: L2TP server setup

Follow the following figure to open Routing and Remote Access. Find the server right-click attribute--Security--Allow L2TP connection to use custom IPSEC policy. Then configure the key. After confirming, restart the service. Enter the configured key when connecting to the client and you can connect normally.

About SECURITY-windows 2008 V pn building method to share here, I hope the above content can be of some help to everyone, you can learn more knowledge. If you think the article is good, you can share it so that more people can see it.