How to configure Cisco Catalyst 4948 for CNA Management

This article analyzes "how to configure Cisco Catalyst 4948 for CNA management". The content is detailed and easy to understand, and friends who are interested in "how to configure Cisco Catalyst 4948 for CNA management" can follow the editor's train of thought to read it in depth. I hope it will be helpful to everyone after reading. Let's learn more about "how to configure Cisco Catalyst 4948 for CNA management" with the editor.

Prepare Catalyst 4500 switch for CNA

Switch restore factory default restore command

Switch > enable

Switch#erase startup-config

Switch#reload

If you want the switch to be managed by CNA, you must have the following two conditions at the same time: have a network management IP address.

Configure IP for g1Acer 1 port

Switch#configure

Switch (config) # interface gigabitEthernet 1 Compact 1

Switch (config-if) # no switchport

Switch (config-if) # ip address XXX.XXX.XXX.XXX 255.255.255.0

Switch (config-if) # no shutdown

The HTTP or HTTPS service is enabled on the default port. The HTTPS port is fixed to 443 and the HTTP port defaults to 80.

By default, the Cisco Catalyst 4500Comp4000 switch cannot be managed by Cisco CNA, so in order to manage the Catalyst 4500Comp4000 switch, it must be configured as necessary.

Switch (config) # ip http server

Switch (config) # ip http secure-server

Add user

Switch (config) # enable secret level 15 "password"

At this point, you can use the CNA connection to manage on the device.

Finally save and restart

Switch#write

Switch#reload

This allows you to use CNA to manage the switch.

On how to configure Cisco Catalyst 4948 for CNA management to share here, I hope that the above content can make you improve. If you want to learn more knowledge, please pay more attention to the editor's updates. Thank you for following the website!