After the computer network cable is plugged in, there is still no solution to the network.

This article mainly introduces the solution that there is still no network after the network cable of the computer network is plugged in, which has a certain reference value. Interested friends can refer to it. I hope you will gain a lot after reading this article. Let the editor take you to know it.

There is still no network solution after the network cable is plugged in: 1, open the network and sharing center, and enter [change Adapter Settings]; 2, right-click the network and select properties; 3, click [configuration], [Advanced], [Speed and Duplex]; 4, change the automatic detection to [10Mbps full Duplex].

Solution:

1. First, right-click the network symbol and select Open Network and sharing Center.

2. Then click change Adapter.

3. Then right-click on the network, and click Properties.

4. Then click configure.

5. Then click Advanced.

6. Then click speed and duplex.

7. Then change the default automatic detection to 10m duplex or half duplex, and click OK.

Thank you for reading this article carefully. I hope the article "there is still no network solution after the computer network cable is plugged in" shared by the editor will be helpful to everyone. At the same time, I also hope that you will support and pay attention to the industry information channel. More related knowledge is waiting for you to learn!