The solution of jumping around all the time when cad can't catch the point

Editor to share with you cad capture points have been jumping around the solution, I believe that most people do not know much, so share this article for your reference, I hope you will learn a lot after reading this article, let's go to know it!

Cad capture point has been jumping around the solution: first of all, open CAD in the computer, and find the "tools" option; then click to enter to find the "drawing settings"; then click on the "object capture" module in the pop-up dialog box, and select the content as needed; finally, click on the "capture and grid" module, and remove the check box before "enable capture".

1. First open CAD in your computer and find the "tools" option in the above column.

2. Click to enter to find "drawing Settings".

3. Click the "object capture" module in the pop-up dialog box, and select the content as needed, as shown in the following figure.

4. Then on the open page, click the "capture and Grid" module.

5. Remove the check box before "enable capture", as shown in the following figure, so that CAD always jumps around when it can't catch a point.

The above is all the content of this article entitled "cad can't capture the solution of jumping around all the time". Thank you for reading! I believe we all have a certain understanding, hope to share the content to help you, if you want to learn more knowledge, welcome to follow the industry information channel!