How to make Android Card Boot firmware

This article focuses on "how to make Android card boot firmware". Interested friends may wish to take a look. The method introduced in this paper is simple, fast and practical. Let's let the editor take you to learn how to make Android card boot firmware.

Cubieboard already supports card startup, and card startup can be achieved by inserting SD-CARD by default. So as long as through a small and

Extremely simple software can make a card to start the firmware.

Of course you should have a card reader and an SD card ready.

Note: this operation should be done in Windows environment!

First of all, download the software PhoenixCard to your computer and extract it. (download at the bottom of this post)

Then open the PhoenixCard_V309 folder and double-click PhoenixCard.exe

The following interface appears:

Set related entries:

1. Insert the SD card reader, click "get drive letter", and it will detect the device.

two。 Then press "Image File", select the Android firmware you want to burn (I take CB2.img here as an example), and then select "Card Boot" in "Burn Mode".

3. After setting up, click "Burn", wait a few minutes, it will burn the firmware into the SD card.

When you're done, it should look like this:

Finally, unplug the SD card from the computer, insert it into the Cubieboard board, then power on, connect the monitor, and you will see that the Android system starts from the SD card!

At this point, I believe you have a deeper understanding of "how to make Android card boot firmware". You might as well do it in practice. Here is the website, more related content can enter the relevant channels to inquire, follow us, continue to learn!