Loadrunner11 monitoring centos6X, express!
Monitored Centos6x machine
First, you need to enable linux RPC (Remote Procedure Call), that is, rpc.rstatd service. You can use ps-ef. | whether grep rsh is installed.
2. Rpc.rstatd installation:
1. Download and install rpc.rstat source code installation package: wget https://nchc.dl.sourceforge.net/project/rstatd/rstatd/4.0.1/rpc.rstatd-4.0.1.tar.gz
two。 Extract the installation package: tar-zxvf rpc.rstatd-4.0.1.tar.gz
3. Enter the decompressed directory rpc.rstatd-4.0.1
4. Execute. / configure (configuration)-- > make (compile)-- > make install (install)
5. Start rpc.rstatd, enter the rpc.rstatd command directly, enter, and start rpc.rstatd
6. Install rpcbind (formerly known as portmap), yum install rpcbind, and enter rpcbind directly after installation
7. Enter rpcinfo-p. If there are two services, rstatd and portmapper, the installation starts successfully, as follows:
Program vers proto port service
100000 4 tcp 111 portmapper
100000 3 tcp 111 portmapper
100000 2 tcp 111 portmapper
100000 4 udp 111 portmapper
100000 3 udp 111 portmapper
100000 2 udp 111 portmapper
100024 1 udp 60747 status
100024 1 tcp 42097 status
100001 5 udp 640 rstatd
100001 3 udp 640 rstatd
100001 2 udp 640 rstatd
100001 1 udp 640 rstatd
3. In loadrunner11-- > Controller, click-> Run-- > Available Graphs-- > Open Unix Resources-- > right click on the Unix Resources figure, as shown below:
4. Add Measurements-- > Open as shown below:
6. After confirmation, the figure is as follows: