How to realize Spiral Ring by SolidWorks Simulation
This article mainly explains "how to realize the spiral circle in SolidWorks simulation". Interested friends may wish to have a look at it. The method introduced in this paper is simple, fast and practical. Next let the editor to take you to learn "SolidWorks simulation how to achieve spiral circle" bar!
one
Modeling
First of all, let's model the spiral and share the modeling for the first time.
When you see this model, the first thing that comes to mind is the way to scan under the features. since you want to scan, you have to have a trajectory, which is a helix, of course. You can basically model here.
1. Draw a circle with a diameter of 100
2. Turn the view to the front datum and look at the circle vertically
3. In the new view direction, establish the sketch environment, draw a line as 15mm, and make the end of the line and the center of the circle have penetration constraints.
4, after completion, scan the small short line, take the circle as the route, specify the rotation value, the number of turns, the direction 15, be sure to check the merge section; after completion, as shown in the figure.
5. Finally, click "scan" under "feature", and select "Circular profile" with a diameter of 12.
Hey, it doesn't look good, or do you want to moisten all kinds of colors?
After that, assembly and simulation are carried out.
Part2 simulation
Assemble, put the spiral circle, and the ball (do not do the ball modeling, follow-up link has the model) into the assembly environment.
Select "path fit" under "Advanced fit".
For simulation, you need to open the Motion plug-in in the plug-in, switch to the "Motion example" module, select Motion analysis, and select the path of the motor.
At this point, I believe that everyone on the "SolidWorks simulation how to achieve spiral circle" have a deeper understanding, might as well to the actual operation of it! Here is the website, more related content can enter the relevant channels to inquire, follow us, continue to learn!
