HillStone-getting started configuration

Hillstone focuses on firewall products, specific introduction can see Baidu encyclopedia: hillstone Baidu encyclopedia introduction

1. Quickly set up local area network

The ip address of the default management port is 192.168.1.1

Log in to the browser http://192.168.1.1, click "Network" on the left side of the panel, and then click "Routing Mode" on the right side of the panel

Click OK to create

You can create several more Ethernet interfaces

You can also create an Ethernet subinterface (an Ethernet subinterface enables one-arm routing between Cisco routers vlan)

2. Ipsec + l2tp * *

Click "IPsec × ×" on the left panel to create a new p1

Create a new p2

Note: the p1 and p2 created here are only applicable to mac,windows.

Create a new Peer

Write down the Pre-shared key you filled in here, which you will need to use when connecting to the client later.

New IKE × × ×

Import imports the Peer created earlier

Click "OK"

Click "L2TP × ×" on the left side of the panel to create a new L2TP × × ×

Click "OK" and the creation is finished.

Create a * user

Once created, the client can then connect.

Create l2tp under mac *

Do you remember the "Pre-shared key" filled in above?

After the connection is successful, you have to add your own routes to access the corresponding network.

3. Port mapping

To create a new service for a port, click "Objects"-> > "Service Book" on the right side of the panel

Click OK to finish the creation!

Reference link: hillstone official technical documentation