How to solve the WISP problem of Wireless Dial-up PPPOE

How to solve the WISP problem of wireless dial-up PPPOE, in view of this problem, this article introduces the corresponding analysis and solution in detail, hoping to help more partners who want to solve this problem to find a more simple and feasible method.

Using the AP CLIENT function to realize the WISP function in the router goes in the wrong direction and bridges the apcli0 to the new bridge br1. At this time, the apcli0 is not in Promiscuous Mode mode and forwards the message. As a result, after the broadcast PAD0 packet is sent, the reply PAD0 packet cannot be received.

Solution:

Just separate the apcli0, when the apcli0 becomes promiscuous mode, and when the connection is successful, a tunnel is created to establish the ppp0 network port for the upper layer information to interact with the kernel information.

At the same time, you need to make changes in the pppd configuration file (/ etc/options.pppoe) to set the last

The eth3.2 interface is replaced by apcli0. Before, the eth3.2 interface was the interface of wan, but now the wireless apcli0 port is used as the interface of wan, so it should be changed to apcli0. In this way the WISP function is implemented.

This is the answer to the question about how to solve the WISP problem of wireless dial-up PPPOE. I hope the above content can be of some help to you. If you still have a lot of doubts to be solved, you can follow the industry information channel to learn more about it.