The method of exploding blocks by cad

This article is about how cad explodes blocks. The editor thought it was very practical, so I shared it with you as a reference. Let's follow the editor and have a look.

The way cad explodes the block: first open the cad software; then type "X"; finally, press the enter key to open the drawing and make a separate line segment between every two points.

Many drawings exist as blocks, so we can only select them as a whole, and if we want to modify their interior, we need to break them up.

Open cad, type "X", and then press enter.

At this point, the drawing has finished opening, and there is a separate segment between each two points.

If you want to restore after opening it, you can use the block command to reassemble the block.

Matters needing attention

Before breaking up, it is best to move the block to an open area to avoid being full of lines after breaking up, which is difficult to select.

Thank you for reading! So much for sharing the method of exploding blocks in cad. I hope the above content can help you to some extent, so that you can learn more knowledge. If you think the article is good, you can share it and let more people see it.