[basic] GNS3 adds boards and basic operations to the router
Experimental purpose:
Add 16 boards to R1.
Let C1 and C2 communicate normally.
The steps of the experiment:
1. Add a board to R1:
open
Just click OK.
Right-click R1 to start R1.
Then double-click R1 and a command prompt appears.
The point displays the interfaces for all ports.
two。 Assign router R1 an IP address:
3. Assign an IP address to PC:
Use the C2ping gateway to ensure that you can communicate, and then use C2ping C1 to also be able to communicate.
4. There are 16 interfaces on R1. If you want to assign an ip address to f1Candle 10, you need to execute a command (no switchport) because its board is a layer 2 card (that is, a switch card), and it is now a router and a switch.
That's OK.
