Where to operate in ppt2010 to set slide show conditions

Where do I set the slide show conditions in ppt2010? In view of this problem, this article introduces the corresponding analysis and answers in detail, hoping to help more partners who want to solve this problem to find a more simple and feasible way.

When setting slide show conditions in PowerPoint 2010, you should do so in the (Slide Show) tab.

PPT2010 sets the slides to play automatically

Open ppt2010, and create a new slide, and edit the file, as shown below is a simple slide edited by the editor. This is just a simple example, which you need to set up according to your own situation.

The editor will play it one by one according to the slide number. To do this, find rehearsal timing in the functional area of the Slide Show menu, as shown in the following figure. Just follow the editor's picture tips.

Click the small arrow in the window during the rehearsal to switch slides. After all the playback is over, the end window pops up, and we click OK. Is it very simple? it's basically set up here.

In the start menu ribbon, select Save as to store the file. A saved procedure operation is required here.

Save ppt as an autoplay file. In this way, all we get is an auto-play slide.

This is the answer to the question about where to set the slide show conditions in ppt2010. I hope the above content can be of some help to you. If you still have a lot of doubts to be solved, you can follow the industry information channel for more related knowledge.