Router changes switch settings

first. From the route or as a route! Setting: route An is a master route, route B is a slave route! Suppose you now have two routes An and B that use ADSL dial-up at the same time. First, set the WAN port status of Route A to PPPoE dialing status, and then fill in the account number and password for ADSL dialing. Then, set the LAN port IP of route A to 192.168.1.1 LAN and the IP segment to 192.168.1.X network segment mask 255.255.255.0. Third, set the WAN port state of route B to static IP,IP address to 192.168.1.2 mask 255.255.255.0 gateway to 192.168.1.1. Fourth, set the LAN port IP of route B to 192.168.2.1 LAN and the IP segment of 192.168.2.X network segment mask 255.255.255.0. Fifth, connect the WAN port of route B with any LAN port of route A. This method can connect 7 computers at the same time! Second: from the route when the switch to use! Setting: 1. First connect the computer to the LAN port of the slave router and change the IP address of the slave route to another network segment address, as long as it is not the same as the main router. For example, most router addresses are 192.168.1.1, we just need to change the address from one router to 192.168.0.1; 2. In the setting, the DHCP function of the slave router will be turned off; 3. Finally, connect the network cable from the master router to the LAN port of the slave router (any one is fine), and note that it cannot be a WAN port.