How to install H3C S5560-EI Series switch system

Editor to share with you how to install the H3C S5560-EI series switch system, I believe most people do not know much about it, so share this article for your reference. I hope you will learn a lot after reading this article. Let's learn about it together.

First of all, download a TFTP software, which is the TFTP text transfer protocol. After installation, connect A with the console line, connect with the computer, and open the terminal (I am using XShell) system-visew (sys). System view interface vlan 1. Enter vlan 1 ip address 192.168.1.1 24. Set the vlan 1 address to 192.168.1.1 put s5560ei-cmw710-boot-r1109.bin 24 and then set the computer local connection address to 192.168.1.2 put s5560ei-cmw710-boot-r1109.bin 24. Secondly, find a network cable, connect the computer to A, open the terminal, and enter the command: put s5560ei-cmw710-boot-r1109.bin 192.168.1.2 and wait for the upload to be completed. Finally, connect both the network cable and the console line to B, and the XShell interface is shown in the figure.

Select 1

Select 1

Fill in yes

After a long wait, the transmission was finally completed, but an error occurred. Finally, there was no way, so I called after-sales service and found that the format of the original system was not .bin, but .ipe format. I downloaded the .ipe compression package on the H3C official website and uploaded it to the switch in the same way, and there was an option to change the file attribute to the main attribute. Then the switch begins to install the system on its own, and the installation is done.

The above is all the contents of the article "how to install H3C S5560-EI Series switch system". Thank you for reading! I believe we all have a certain understanding, hope to share the content to help you, if you want to learn more knowledge, welcome to follow the industry information channel!