How to set up the WIFI client on the Internet

When the router is used as a WIFI client to access the Internet, the WAN port accesses the AP through WIFI. This article uses the F3X36 series router of Xiamen Sixin.

Settings are as follows:

(1) Configure WAN port settings according to AP router. If AP router has DHCP server enabled function,

WAN port settings can be "auto-configuration-DHCP" mode or "static IP" mode. If AP router

If DHCP server is not enabled, WAN port is set to Static IP mode. Examples are as follows:

Under Settings---Basic Settings, the Connection Type is set to static IP, and the gateway is the gateway of AP. "Local

IP address "To set a different network segment than AP.

(2) Configure the router WIFI parameters, first configure the AP router, and then follow the AP router.

Configure WIFI configuration as a client. Go to the configuration page,"Wireless" --- "Basic Settings,"

You can configure the parameters of WiFi.

Wireless Mode, configured as Client Mode. The rest of the configuration is consistent with the AP router configuration. Examples are as follows:

if that AP rout has encryption configured, ent the "wireless security" configuration item to configure security with the AP router

Configuration consistent. If the AP router security mode uses WPA2P, TKIP encryption, password is 12345678, then the client route

An example of the slave configuration is as follows:

After WIFI connection, you can check the connection status under "Status"-"Wireless".