Ghost usage plan

Ghost is one of the most common network security software about data backup.

The best way to use: after completing the installation of the operating system and various drivers, install the commonly used software (such as antivirus software, media playback software and office office software) to the disk where the system is located, then install various patches of the operating system and commonly used software, and then optimize the system, and finally use the boot disk to boot to DOS to do the clone backup of the system disk, pay attention to the size of the backup disk can not be smaller than the system disk.

If you want to clone the backup after installing the system for a period of time because of carelessness, you should first remove the junk files from the system disk and the junk information in the registry (windows optimization master is recommended), then defragment the disk, and then go to DOS for cloning and backup.

Under what circumstances do I restore the cloned backup? When you feel that the system is running slowly (most of which are often installed and uninstalled software, residual or mistakenly deleted some files, resulting in system disorder), when the system crashes, and when there is a virus in the system that is difficult to kill, you can clone and restore. Sometimes if you don't defragment the disk for a long time and don't want to spend half an hour or more, you can restore the cloned backup directly, which is much better than simply defragmenting the disk. It is important to note that the target hard disk must be partitioned when backing up and restoring.