Usage and introduction of nat port command of load balancing Array
The following brings you the usage and introduction of the nat port command of load balancer Array, hoping to give you some help in practical application. Load balancing involves more things, there are not many theories, and there are many books on the Internet. Today, we will use the accumulated experience in the industry to do an answer.
The usage of the nat port command is shown in the figure below, extracted from the Array command line manual.
Show nat table, which displays the NAT (address translation) table that has occurred in the system.
Today, I happen to meet such a demand from the customer. The order is as follows:
# nat configuration
Nat port 10.142.22.30 10.142.22.0 255.255.255.0 60
Note: when using the nat port command, the backend CVM gateway address must point to the virtual address of Array (if it is a single device, the gateway is the real address of the device). For example, 10.142.22.30 configured above is Vip. Maybe the person who wrote the manual thought it was common sense and ignored it.
After reading the above usage and introduction of the nat port command of load balancer Array, if you have anything else you need to know, you can find out what you are interested in in the industry information or find our professional and technical engineers for answers. Technical engineers have more than ten years of experience in the industry.
