How to deploy instance to OVS vlan100
In this issue, the editor will bring you about how to deploy instance to OVS vlan100. The article is rich in content and analyzes and narrates it from a professional point of view. I hope you can get something after reading this article.
Deploy instance to the network today.
Launch's new instance "cirros-vm1", the network chooses vlan100.
The IP assigned to cirros-vm1 is 172.16.100.3.
The cirros-vm1 is schedule to the control node, and its virtual network card is also connected to the br-int.
The connection mode between virtual network card and br-int is no different from that of local and flat network, so I won't repeat it.
Continue to launch instance cirros-vm2 in the same way, and the assigned IP is 172.16.100.104.
The cirros-vm2 is schedule to the compute node, and the virtual network card is connected to the br-int.
Because there is no hdcp service on the compute node, there is no corresponding tap device.
Cirros-vm1 (172.16.100.3) and cirros-vm2 (172.16.100.4) are on different nodes and are connected through vlan100. PING is performed below to verify connectivity.
Execute ping 172.16.100.4 in the cirros-vm1 console
As we expected, ping was a success.
The above is the editor for you to share how to deploy instance to OVS vlan100, if you happen to have similar doubts, you might as well refer to the above analysis to understand. If you want to know more about it, you are welcome to follow the industry information channel.
