The way of Windows Operation and maintenance-- PXE Network Control system

In an enterprise, if we purchase dozens or hundreds of new computers, we still use the traditional installation method, so the efficiency is very low, then we can take the network installation system, we need to build a network server, and then set up the client to boot from the network, which can quickly and efficiently install the operating system.

First of all, we need to prepare Netcom tools and image files, such as Qidong Ruiteng Netcom tools and pre-packaged GHO image files, as shown in the following figure

In the second step, we need to configure the ip address of the Netcom server. We need to set a static ip address with a subnet mask of 16 bits, as shown below:

Step 3: run the PXE software, select the image file, and click "start Network Clone", as shown below:

The server is configured, as shown below:

Next, we just need to connect the server and the client to install the system to the same local area network, click f12 to boot continuously, enter the startup item selection, and set the client to boot from the network card, as shown in the following figure:

Enter the Netcom interface, as follows:

If the client connects successfully, you can manually set the connection for the client, as shown in the figure below:

Ghost

Enter the image file name

Click the OK key twice

Click "Fast" to install

Check the number of clients on the server, and click "send" correctly, as shown below:

The client begins to accept and install until the installation system is successful:

The system will restart automatically during the installation process, as follows:

The system installs the driver as follows:

As shown in the following figure, the system installation is complete and goes to the desktop:

At this point, the net gram system is complete!