How to use fping, a host scanning tool, for Linux common network tools

This article introduces the knowledge of "how to use the host scanning tool fping of Linux common network tools". In the operation of actual cases, many people will encounter such a dilemma, so let the editor lead you to learn how to deal with these situations. I hope you can read it carefully and be able to achieve something!

There are many powerful network scanning tools under Linux. Network scanning tools can be divided into host scanning, host service scanning, routing scanning and so on.

Fping is a host scanning tool, which can scan hosts in batches compared to the ping tool.

Fping official website: http://fping.org/

Source code compilation and installation of fping

Visit fping's official website and get the source code address:

Compile and install commands:

The code is as follows:

Wget http://fping.org/dist/fping-3.10.tar.gz

Tar-xvf fping-3.10.tar.gz

Cd fping

. / configure

Make

Make install

With the above command, fping is installed to / usr/local/sbin/fping.

Introduction of common parameters of fping

The main parameters of fping are as follows:

-a: only surviving hosts are displayed

-u: only non-surviving hosts are displayed

-l: circular ping

How to enter the destination IP address:

The code is as follows:

Fping IP1 IP2 IP3...

Fping-f filename

Fping-g IP1 IP2 (IP1 address start range, IP2 address end range)

The following is an example of input:

This is the end of the introduction of "Linux common network tools how to use the host scanning tool fping". Thank you for reading. If you want to know more about the industry, you can follow the website, the editor will output more high-quality practical articles for you!