Workstation implements the interworking of different network segments in host only or nat mode

Install workstation under 1.windows7, and enter services.msc to find [Routing and Remote Access] to confirm that the service is enabled.

two。 Open workstation and click "Edit"-"Virtual Network Editor"

3. In the virtual network editor, click [add]-[add Virtual Network] to select the network and network mode you want to add.

4. Open the CMD window under the windows7 where workstation is installed, and enter route print to see the routing information of each network segment, including the interface address leading to the network segment.

5. After installing the virtual machine in Workstation, set the IP address to the address in the network segment selected when adding the virtual network, and the gateway to the interface address that leads to the network segment. Take the addition of [host-only mode] 192.168.30.0and24 network segment as an example.

6. Test results: in the virtual machine, ping the virtual machine in the network segment of another virtual network.