Suse chkconfig notes the startup sequence through the service program.

This article introduces the startup sequence of suse chkconfig annotations through the service program, the content is very detailed, interested friends can refer to, I hope it can be helpful to you.

A search on the Internet found that many people said that suse linux's suse chkconfig could not specify the startup order of the service, but it was not. Refer to the service program under / etc/init.d/, which can be set through the comments of the service program.

Suse chkconfig gives examples such as xntpd:

# BEGIN INIT INFO # Provides: xntpd ntpd # Required-Start: $remote_fs $syslog $named # Required-Stop: $remote_fs $syslog # Default-Start: 2 35 # Default-Stop: 0 16 # Description: Start network time protocol daemon (NTPD). # END INIT INFO

Set Required-Start:suse chkconfig to start after the specified service starts.

On the suse chkconfig through the service program comments on the startup sequence is shared here, I hope the above content can be of some help to you, can learn more knowledge. If you think the article is good, you can share it for more people to see.