A complete tutorial on connecting computers to SAIL-IMX7D development boards through ssh

The complete tutorial for connecting 7D development boards to computers through ssh is as follows:

1. Start the development board

Enter the user name root to enter the development board system.

3 [endif] connect the development board and the computer to the same router with a network cable, and the development board prints out the following information. Please remember the information in the red box, eth0:

Link becomes ready . Eth0 indicates the name of the network card you are connected to the router. Link becomes ready indicates that the connection was successful.

4. Use the command ifconfig eth0 to get the information of the network card eth0. If your router has DHCP enabled, the network card will be automatically assigned an ip address. If it is not enabled, you can also configure ip manually.

PS: manually configure the ip address. Configure eth0 with the ip address of 192.168.1.123 through ifconfig eth0 192.168.1.123

5. When I open the ssh tool on my computer, I use xshell. Enter 192.168.1.123 in the host computer. This is the ip address I manually configured for the board. Then click OK and click Connect in the pop-up dialog box. Then enter the user name root in the pop-up dialog box and click OK to connect to the board.

In this way, our computer is successfully connected to the 7D development board through ssh, and friends can try it by themselves. I look forward to sharing my knowledge with you next time.