H 310 # 710 array card configuration.

If you need to clear the configuration and do it all over again, please refer to the following (this operation will empty the hard disk data, please back up the important data in advance)

Press CTRL+R to enter the array card interface when booting.

1. Press F2 on the array card H310, select clear config clear configuration, and then select Yes

If the newly added hard disk is in the state of non-raid, you must first convert it to ready before you can make the array. If it is in the state of ready, you can do the array directly.

Select the hard drive of non-raid press F2 to select the convert to raid option, and then select yes, the hard drive will become ready state.

The picture is a little different, and the option is similar to this one.

two。 Or press F2 on the array card and select Create new VD

Select raid5, select the hard disk to be the array

Select the hard drive by space

Enter the capacity of the first virtual disk to be set in the VD size below, which is usually installed on the system disk, no more than 2T. Then click OK, and then OK

This creates a VD.

3. Press F2 on disk group and select Add new VD

There is no need to change the rest, the capacity of this VD is the rest of the space, then click OK, then click OK

Just create 2 VD

Two VD need to be initialized (all data will be emptied, please back up)

4. Select ID:0, press F2, select Fast init., in Initialization, also choose ID:1 to do the same operation.

5. Press CTRL+N twice to enter the interface of CTRL MGMT, make sure the above two options are selected, then select boot device, select VD0, this is to set the first virtual disk as the startup item of the system, then select APPLY to save, and then press ESC of the keyboard to exit to restart the installation system.