Installation and configuration of CodeBlocks TMD-GCC under windows

I started programming with C when I was a freshman. At that time, I installed the VC++, interpreter directly and installed it for you. Recently came into contact with CodeBlocks, only to know that this product needs to configure their own GCC, this is the focus of this article.

First download TMD-GCC: http://tdm-gcc.tdragon.net/download

I downloaded tdm64-gcc-5.1.0-2 (because my computer is 64-bit)

Install the software:

①: be careful not to select the following box, as shown below:

②: select the installation address

③: verify whether the software (GCC) is installed successfully. Enter the following information in the CMD panel (DOS): gcc-v is successful.

All right, start configuring the software codeblocks.

①: Settings- > Complier enter the interface shown in the following figure and make the settings in the interface

All right, let's compile and run the program.

Take a look at the open console (below):

All right, this is the perfect end of the compilation environment in which the CodeBlocks is configured with Candlestick +. Thxs .