Use the sndconfig command of linux to set up a sound card

This article will explain in detail how to use linux's sndconfig command to set up a sound card. The editor thinks it is very practical, so I share it with you for reference. I hope you can get something after reading this article.

The sndconfig command is used to set up the sound card. This command supports the PnP setting and automatically detects and sets the PnP sound card.

The full name of PnP is Plug-and-Play, which is translated as plug and play. The role of PnP is to automatically configure boards and other devices in low-level computers, and then tell the corresponding devices what they have done. The task of PnP is to coordinate the physical device with the software device driver and operate the device to establish a communication channel between each device and its driver. Then, PnP allocates the following resources to the device and hardware: Imax O address, IRQ, DMA channel, and memory segment.

Syntax format: sndconfig [parameters]

Common parameters:

Reference example

Set not to automatically check the sound card mode:

[root@linuxcool] # sndconfig-- noautoconfig

Set to a sound card that does not automatically set PnP:

[root@linuxcool ~] # sndconfig-- so much for noautoconfig to set up a sound card using linux's sndconfig command. I hope the above content can be helpful to you and learn more. If you think the article is good, you can share it for more people to see.