12V Mustang 215X 6 interface test: it will not repeat the mistake of 12VHPWR and can work properly without correct installation.
CTOnews.com September 26 news, according to the latest video shared by YouTube channel Hardware Busters, as the successor to the 12 V HPWR interface, the 12V-2×6 PCIe interface can work normally within the specification range even if it is not installed correctly, without burning.
CTOnews.com attaches a screenshot of the test as follows, using Jartul JT 6322A (1200 W / 150 V / 240 A) DC electronic unit to load the 12V-2×6 cable, even if it is not inserted correctly, it is found that the reading of the interface in voltage, current and power is basically unchanged, and it can withstand a load of nearly 645W.
The new CEM 5.1 specification replaces the existing 12 V HPWR interface with a new 12V-2×6 interface, and as a base specification, PCI SIG directly defines its common form factor, maximum and continuous power parameters, so it is less confusing.
12V-2×6 port not inserted correctly
Properly plugged into the 12V-2×6 port, this connector supports 675W graphics (connector 600W+PCIe power), while the motherboard PCIe slot (PEG) still has a maximum of 75W power. For comparison, the previous CEM 5.0 had a maximum power of 600W.
Related Reading:
PCI SIG CEM 5.1 (ATX 3.1) specification will adopt 12V-2×6 connector