Shulou(Shulou.com)06/01 Report--

This article will explain in detail about 2003 and xp how to set up isatap tunnel to obtain IPv6 address. The editor thinks it is very practical, so I share it with you for reference. I hope you can get something after reading this article.

First of all, the system installation supports IPv6 protocol.

1. Select "Local connection-Properties-installation" with the right mouse button

2. Click "install", select "Protocol-Microsoft--Microsoft TCP/IP version 6", and click OK to install.

3. After the installation is complete, you will see that the "Microsoft TCP/IP version 6" protocol has been installed in your local connection.

Second, at start-run, type cmd, enter the command prompt, and configure the tunnel at the command prompt

1. Configure tunnel isatap to obtain IPv6 address

Tunnel point IP:isatap.scau.edu.cn (192.168.253.49) Tunnel method: isatap

C:\ > netsh

Netsh interface ipv6 isatap > set router isatap.scau.edu.cn (add disabled after cancellation)

Then after ipconfig, you should see a V6 address prefixed with 2001:da8:2004:2001, hostid is 5efe:x.x.x.x, where x.x.x.x is your real IPV4 address.

2. Ping whether the IPv6 website of our school is connected, it means that it is normal.

This is the end of the article on "2003 and xp how to set up isatap tunnel to get IPv6 address". I hope the above content can be helpful to you, so that you can learn more knowledge. if you think the article is good, please share it for more people to see.

Welcome to subscribe "Shulou Technology Information " to get latest news, interesting things and hot topics in the IT industry, and controls the hottest and latest Internet news, technology news and IT industry trends.